Immersion heaters

Immersion heaters
	Introduction
	Standard models for water
	Standard models for oil, fuel and pulsated air
	Accessories
	Other products
	Enquire for a quotation or place a purchase order

Accessories

Products > Immersion heaters > Accessories

STANDARD REFERENCES:

OPTIONS:

Soldered stainless steel screw plug.

TIG soldered stainless steel screw plug

Thermowell for probe

Enclosed thermostat, interior or exterior adjustement.

ALUMINIUM TERMINAL ENCLOSURE:
I.P.55 adjustable

M45 and G''1/2. PE n°21
76x76xH 65 mm
REF.

M77 and G2''1/2 PE n°21
100x100x H90 mm
REF.

Advice to the user:

The active part of the heater must be permanently immersed or ventilated.

Terminal temperature must not exceed 80°C

Provision for earthing should be in accordance with current standards.

Horizontal mounting recommended with circulating fluid evacuation at the opposite end from the connectors.

The active part of the element should always be located outside the sleeves.

For pressures > 15 bars, use flange-mounted heaters.

Carefully check the watt density (W/cm²) is compatible with the static and dynamic thermal characteristics of the fluid to be heated.

At fluid temperatures > 110 °C, allow dfor an offset (D) of 100 mm up to 200°C and 150 mm above.

GUARANTEE:
No guarantee can be given in the event that specified conditions of use are not observed.